Pneumatic Veneer Clipper
Defects of traditional control:
a. We do not know the cutting length beforehand and it needs further readjustment to make sure if the measuring size is correct after cutting, thus the waste occurred.b. When drying speed is changed, it must be remeasured and readjusted once again.
c. When the different speed of air cylinder is waving right and left, when the cutting size will become different. This will result in one size longer than the other one.
TYPE |
CEP-2700 |
CEP-3300 |
ADAPTABLE WIDTH VENEER TO BE CUT MAX |
2600 mm |
3320mm |
KNIFE WIDTH |
2860 mm |
3350mm |
STOCK OF KNIFE |
65 mm |
65 mm |
FEEDING SPEED |
5-60 M/min |
5-60 M/min |
MOTOR FOR IN FEED CONVEYOR |
5HP*4p |
5HP*4p |
CUT THICK |
0.4-4.5 mm |
0.4-4.5 mm |
COMPRESSED AIR SUPPLY |
4-6 kp/cm2 |
4-6 kp/cm2 |